Model 5225 Series Shielded Enclosure
www.ets-lindgren.com
Before connecting components, read
on the back page of this document.
Safety Information
Setup Instructions
Raise the lid handle to open the door of the Model 5225.
1.
2.
(As required by the testing you want to perform) Attach cables to the SMA connectors
on the antenna patches.
4.
Place EUT inside the Model 5225 and connect cables as required.
Lower the lid handle to close the door of the Model 5225.
6.
5.
Attach a power cable to the IEC power connector.
3.
(As required by the testing you want to perform) Connect cables to the DB-9 and
fiber optic feedthroughs.
Apply power to the Model 5225. Perform testing as required.
7.
Note:
ETS-Lindgren may substitute a similar part or new part number with the same functionality
for another part/part number. Contact ETS-Lindgren for questions about part numbers and
ordering parts.
Shielding Specifications
Filter Specifications
Attenuation
100 dB, 5 MHz–6 GHz
Current
10 Amps
Voltage
100—250 VAC
Operating Frequency
0 Hz–60 Hz
Insertion Loss
100 dB, 5 MHz–18 GHz
Electrical Specifications
Weight
22.0 kg (48.6 lb)
Physical Specifications
External Dimensions
Length:
Width:
Height:
71.1 cm (28.0 in)
43.2 cm (17.0 in)
60.9 cm (24.0 in)
Internal Dimensions
(Absorber to Absorber)
Length:
Width:
Height:
60.5 cm (23.8 in)
32.3 cm (12.7 in)
50.3 cm (19.8 in)
Coupling Loss
Typical Coupling Loss Repeatability
+/- 1 dB
Typical Internal RF Absorption
2 GHz–6 GHz
Typical RF Isolation
2 GHz–6 GHz >80 dB
Better than -36 dB from
5 GHz to 6 GHz for
high frequency antennas
•
(~25 dB at 5.5 GHz) using
identical antennas at 10 cm
from antenna surface
•
•
30 dB to 35 dB minimum
at the 2.54 band for
low frequency antennas
Connectors
•
SMA feedthrough (2)
•
Fiber optic feedthrough (1)
•
Filtered DB-9 feedthrough (1)
•
Type N (1)
•
IEC power (1)
