ETOP ATX-E15, Руководство пользователя

Страница: 42 / 90

34 ATX-E15 User`s Manual
BIOS Introduction
This manual describes AMI's Setup program, which is built into the
ROM BIOS. The Setup program allows users to modify the basic
system configuration. This special information is then stored in
battery-backed RAM so that it retains the Setup information when
the power is turned off.
Starting Setup
The following pages are meant to give you a better insight into the
options you have to setup your system. Many options depend on the
choice of type of memory, memory speed, peripherals and the
programs that you will be running. The effective of these settings are
related to system performance that can destabilize operation. We
urge you to proceed with caution
.
When the system is powered on, use the bios set program when you
start up your system, reconfiguring your system, or press “Delete”
promptly to run setup. This section will explain how to configure
your system using this utility. And this change will be recognized and
record them in the CMOS RAM of the SPI chip.
When you start up the computer, the system provides you the
opportunity to set the program. Press the “del” during the P.O.S.T
(Power-on Self-Test) to enter the program setting. And the POST will
continue with the test routines. And the firmware chip will store the
setup utility on the board. However, if you want to enter the setup
after the POST, you can press Ctrl + Alt + Del simultaneously or turn
off the power then back on.