Eton PA 4506, Руководство по установке и эксплуатации

Страница: 13 / 16

25
Configuration Examples
Full active Operation
Attention:
It is absolutely mandatory to observe the technical specifications of the loudspeaker manufacturer.
If the frequency is too low for the tweeter, it will definitely result in irreparable damage.
Before turning on the amplifier you should place all volume controllers at minimum. The sensitivity controllers
(8,12 and17) should also be adjusted to the lowest sensitivity level (4.3 V).
Bassboost
The bass reproduction can be increased at 45 Hz between 0 and 12 dB. Simply turn the controllers (20;32)
until your listening taste has been satisfied.
Filter Selection Full Active System
Place mono/stereo switches (9, 13) in STEREO position
Place signal entry selection switch (19) in FRONT position
Place signal entry selection switch (14) in FRONT position
Place filter switch (21) in ON position
Place filter selection switch (22) in HP position
Place multiplier switch in X20 position
Using the filter controller (23) adjust the take over frequency of the tweeter between 600 Hz and 3000 Hz.
Place filter switch (25) in OFF position
Place filter switch (27) in ON position
Place multiplier switch (29) in X20 position
Using the filter controller (28) adjust the take over range of the midrange speaker between 600 Hz and
3000 Hz.
Place remote control switch (30) in ON position
Place phase switch (33) in ON position
Place HP filter switch (35) in OFF position
Place LP filter switch (37) in ON position
Using the filter controller (38) you can now adjust the transmission range for your subwoofer between 45 to
300 Hz according to your listening taste.
Now tune the entire system to satisfy your listening taste.
Woofer
Left
Tweeter
Left
12V
switched
Woofer
Right
Tweeter
Right
FUSE
SOURCE UNIT
PA 4506
SUB
PA 4506