ETNA EKP358RVS, Инструкция по эксплуатации

Страница: 47 / 52

EN 11
General
If you notice a crack in the glass top (however small), switch the hob
off immediately, unplug the hob, turn off the (automatic) fuse switch(es)
in the meter cupboard or, in the event of a permanent connection,
set the switch in the power supply lead to zero.) Contact the service
department.
Troubleshooting table
If the appliance does not work properly, this does not always mean that
it is defective. Try to deal with the problem yourself first by checking
the points mentioned below.
Symptom Possible cause Solution
A slight smell is noticeable
the first few times the hob is
used. The new appliance is heating
up. This is normal and will
disappear once it has been
used a few times. Ventilate
the kitchen.
You can hear a ticking sound
in your hob. This is caused by the
capacity limiter on the front
and back zones. Ticking can
also occur at lower settings. Normal operation.
The hob is not working. There is no power supply
due to a defective cable or a
faulty connection. Check the fuses.
A fuse blows as soon as the
hob is switched on. The hob has been wrongly
connected. Check the electrical
connections.
FAULTS