Installation
-
Clean the door on which the detector will be
installed.
-
Tear apart the double-sided tape on the front of
the magnet and fix it to the desired location. The
magnet must be installed less than 2 cm away
from the transmitter
For stronger installation, the detector can also be
mounted with screws: remove the plastic cover of
the magnet and drive two screws through it.
If mounted on a metal door or window and
transmission signal is not sufficient, place a non-
metallic layer under the magnet.
Register the detector in the alarm system
Switch to Connection Mode on the control panel.
Separate the magnet of the detector from its
transmitter. The control panel beeps once: the
detector is registered. If you hear two beeps, the
detector has already been connected.
+ 12/23 Battery -
Jumpers for
Zone setup
Wired Magnet-
ic Door Sensor
Inteface
D3
D2
D1
D0
