SETUP
Page 12
DOC_DEV_XS_Setup guide_C
Use a different address for the serial gateways
By default, the IP address of the serial gateways is the IP address of the administration server of the XS.
It may be necessary to set a different IP address for the serial gateways especially when VLAN is enabled; in
this case, this box must be checked and an IP address and a subnet mask must be entered.
Default value : Unchecked
Enable IPV6
The IP addresses assigned to the XS must be entered in IPV4 format.
However, the switch also supports IPv6 addressing. If this is checked, IP addresses must also be entered in
IPv6 format.
Default value : Unchecked
•
Configure
Routing between SHDSL and LAN
parameters:
Router mode
The XS acts as a managed switch.
However, if this box is checked, the XS provides basic IP router features between two interfaces:
LAN Ethernet 10/100BT ports,
and SHDSL ports.
The Ethernet ports are considered as a single interface; SHDSL ports (1 to 4 depending on model) are also
considered as a single interface. The XS must have two IP addresses. The one previously defined only applies
to LAN Ethernet ports and a new one must be defined for SHDSL ports.
The main purpose is to prevent the broadcast frames or other frames to congest the SHDSL lines.
Default value : Unchecked
The following parameters are only displayed when the IP router mode is selected.
IP address
This is the unique IP address assigned to the SHDSL interfaces of the XS.
Default value : none
Netmask
Subnet mask for the network on the SHDSL port side.
Default value : 255.255.255.0
Enable IPV6 on SHDSL ports
See above.
Default value : Unchecked
Содержание XLAN+ Series
Страница 6: ......
Страница 49: ...SETUP DOC_DEV_XS_Setup guide_C page 49 ...
Страница 74: ......
Страница 82: ......