South Bend, Indiana USA
|
networketi.com
MOISTURE SENSOR CUP INSTALLATION MANUAL | PART NO.
23975
REV
A
2
INSTALLATION INSTRUCTIONS
The optional moisture sensor cup can be used either to
retrofit an existing moisture sensor or when installing a
new sensor. In either case, the most critical issue regarding
its installation is that the bottom of the moisture sensor cup
must be perpendicular to the grid lines in the sensor end.
To retrofit an existing sensor or to fit the adapter over a
new sensor prior to installation, perform the steps below.
1. Position the moisture sensor cup over the far end
of the moisture sensor, opposite the end with the
electrical wires. Refer to Figure 2.
2. Align the moisture sensor cup mounting groove over
the flanged end of the moisture sensor. The sensor
cup was designed to fit and mate snugly over the
moisture sensor flange to help hold it in place.
3. Push the moisture sensor cup down over the moisture
sensor flange until it snaps into position and is
properly seated on the moisture sensor.
4. Once the adapter has been secured in place over
the moisture sensor flange, gently rotate the adapter
in either direction until the bottom of the cup is
perpendicular to the sensor end grid. Refer to Figure 3.
5. With the moisture sensor cup now in place over the
moisture sensor and aligned perpendicular to the
end grid, moisture sensor installation may proceed.
Make sure upon sensor installation to rest the adapter
on its two feet along the bottom of the gutter as this
is the optimum positioning for the proper function of
the moisture sensor cup.
QUESTIONS AND COMMENTS
For technical help, questions, or comments concerning
this or any ETI product, contact the Customer Service
Department between 8:00 a.m. and 5:00 p.m. EST.
E-mail:
LIMITED WARRANTY
ETI’s two year limited warranty covering defects in
workmanship and materials applies. Contact Customer
Service for complete warranty information.
DISCLAIMER
ETI makes no representations or warranties, either
expressed or implied, with respect to the contents
of this publication or the products that it describes,
and specifically disclaims any implied warranties of
merchantability or fitness for any particular purpose. ETI
reserves the right to revise this publication, and to make
changes and improvements to the products described
in this publication, without the obligation of ETI to notify
any person or organization of such revisions, changes or
improvements.
Copyright © 2019 ETI,
®
All rights reserved.
