Use and Care GUide
direCT/indireCT WraP LiGHT
nOTe
:
Keep your receipt and these
instructions for proof of purchase.
WarninG
:
Shut off the power at the
circuit breaker or fuse panel before
removing the old fixture, ballast, or
fluorescent tubes.
If you are unfamiliar with electrical
installations, we recommend you contact a
qualified electrician to do the installation.
INSTALLATION
nOTe
:
Installing contractor is responsible
for selecting a suitable location that can
support the weight of the fixture and
determining the method for mounting the
fixture before installing, based on the type
of ceiling.
Shut off power at the electrical panel
before beginning the installation.
Remove fixture and set aside to recycle
in accordance with local requirements.
Remove end trim from fixture by sliding it up.
Unlock lens at both ends of the fixture.
Lens swings open.
3
PAckAge cONTeNTS
Part Description
Quantity Accessory Model #
A
Fixture
1
NA
B
Continuous Mounting Bracket
1
NA
C
Toggle Bolt
2
NA
D
Thumb Screws
2
NA
E
Ring
1
NA
F
Mounting Chain
2
NA
G
V Clip Chain
2
NA
H
Jumper Wire
5
NA
I
Mounting Plate*
1
J
Mounting Screw*
2
K
Nut*
2
L
3/8” Conduit*
1
M
Hook*
2
N
Screws*
2
O
Plastic Drywall Anchor*
2
P
Stem Mounting Kit Screws*
2
Q
Stem Mounting Kit Nut*
2
R
Stem Mounting Kit Bracket*
2
S
Ceiling Plate*
2
T
Stem*
2
Hardware not shown to actual size.
* Accessory sold separately
1
2
Squeeze the tabs at both ends of the wire cover and
remove the wire cover.
Unplug the terminal ground wire from the fixture and the
wire cover.
4
A
End Cap
Model # 56567241
Part # Wr-4FT-6700LM-8-40K-MV-LVd
Certification # 56567241
Hold the fixture to the desired ceiling location and
mark the two keyholes (47in. apart). Punch out
the desired knock out hole that will be used for
wiring.
If mounting to drywall:
Drill two 3/4in. holes in
the ceiling. Fasten the toggle bolt into the butterfly
nut (not included) before inserting the flaps of the
toggle bolt into the ceiling, but do not fully tighten.
nOTe
:
Toggle bolts are only to be used for
mounting the fixture to plaster or drywall surfaces.
The installing contractor is responsible for
selecting the appropriate mounting hardware.
5a
SurfAce MOuNTINg
6a
Insert the ring into the knock out hole and feed the
wires from the fixture through the ring.
Make the electrical connections by inserting the wire
into the respective wire connector:
• Black wire to black wire.
• White wire to white wire.
• Green wire to ground wire.
• If a 0-10v dimming circuit is available, connect
purple wire to purple wire and gray wire to gray
wire.
Tuck wires inside the electrical box.
7a
8a
Place the keyholes in the fixture around the toggle
bolts in the ceiling and tighten the toggle bolts. Make
sure the fixture is secure.
9a
B
D
C
E
G
Lens
A
Lens
Terminal
Ground Wire
Wire Cover
Knock out hole
Keyhole
A
Lens
A
Lens
Wire Connector
A
C
C
F
H
I
J
K
L
M
N
P
O
Q
R
S
T
A
Safety Rope
E
