Etherstack SFFR-6, Руководство пользователя

Страница: 16 / 39

SFFR-6 User Manual
Getting Started
Doc ID: ES1002-UM02-v204a Copyright © 2014 Etherstack London Limited Page 16 of 39
2.2.5.3 Status Window
The status window displays the currently selected operational profile, power level of each battery, status of the on-board
battery charger and external power source if AC and/or DC power is connected.
2.2.5.4 Backlight Button
The backlight button when pressed will engage the LCD backlight for several seconds so the LCD display can be more easily
viewed if external lighting conditions are poor.
2.2.5.5 Power Button
The power button when pressed and held down will toggle the power status of the GoBox.
2.2.5.6 Rotary Dial and Button
The rotary dial is used to quickly select different operational profiles.
On pressing the rotary dial, the status window backlight will automatically illuminate and remain on until the rotary dial
button is released. You can turn the dial to select any of the available and pre-configured profiles.
Once a profile has been found, releasing the rotary dial push button will commence a reconfiguration of the GoBox. During
this time the Green Power LED will flash indicating a reconfiguration is in progress. When the Green Power LED turns solid,
the GoBox is ready for operation.
2.2.5.7 Tx and RX LED
On receiving a signal on the frequency the GoBox is programmed for, the yellow Rx LED will illuminate for the duration of
the signal. The red Tx LED will illuminate to indicate that the signal has been repeated.
2.2.5.8 Power LED
On power-up, the GoBox will perform a series of self-tests to ensure all elements are operational. During this time the LED
will flash to indicate that power is on but he GoBox is not yet operational. Once the LED turns a solid Green, the GoBox is
ready for use.
2.2.6 Radio Module
The radio module houses two high performance radio transmitters and receivers. These modules are band specific and will
be pre fitted based on the frequency band of the duplexer fitted at the time of order.
The backlight is on a timeout to ensure it is not left on and otherwise drain the batteries unnecessarily.
!
The power button must be held done for several seconds to avoid accidental power on/off scenarios.
!
To avoid accidental profile changes, the rotary dial must be pressed during rotation.
!
Based on the configuration profile, the Tx LED may not illuminate.
!
The GoBox when first unpacked will not have any operational profiles to execute. Until the GoBox has been
configured, the Power LED will continue to flash, indicating it is in the programming state.
!
The GoBox radio modules have been designed to run at high temperatures in order to support the power output
and high duty cycles typical of a heavy use repeater/base station. Care must be taken if the GoBox has been
running for several hours supporting a large volume of calls. The front panel of the radio module can exceed 50
o
C.
!