7
A S S E m B ly A n D o p E r A t i n g i n S t r u C t i o n S | e n E x H o - i C - F i r E D E t E C t o r S
If you have installed the eNEXHO-IC fire detector
in a eNEXHO home-automation installation, once it
has been reset, the detector will not send warning alerts
for possible detections until you have re-configured it. To
re-configure it, please refer to the manual of the eNEXHO-
NT internet module and follow the steps described in the
section on how to install the corresponding detector in the
home-automation network.
In order to reset the eNEXHO-IC fire detector, press the ins
-
tallation button once. The green indicator light on the circuit
board will come on. Wait until the indicator light starts to flash
and, at that point, press the button again. The light will start
to flash more slowly and will stay on for a few more seconds.
When the light goes off, the reset process is completed.
H o W D o i r E S E t A e n E x H o - i C F i r E D E t E C t o r ?
Please note that if you have installed the device in a eNEXHO home-automation installation, the eNEXHO-NT internet
module will display a warning if the battery of one of the devices is low.
The eNEXHO-IC fire detector allows you to perform a magnetic
test to check the proper functioning of the device.
In order to perform a test, hold a magnet to the pilot light of the
device head. At this point, all device warning light indicators
should light up. After a few seconds, the alarm will emit an
audible warning signal.
If this does not happen and the device is running on battery
power, replace the battery and perform a new test.
H o W C A n i t E S t t H At t H E e n E x H o - i C F i r E D E t E C t o r i S W o r K i n g p r o p E r ly ?
WHEn trouBlESHooting
plEASE ContACt tHE CuStomEr CArE oF your SpECiAliSt DEAlEr.
IndIcatIon:
Subject to technical modifications. Changes, errors and misprints shall not be entitled to compensation.
WarnIng:
Electrical and electronic appliances often contain prescious materials. But they can also contain harmful substances that were necessary
for their function and safety. They can harm the environment if disposed or mishandled. Please help to protect our environment! Therefore do not
dispose of this device in the residual waste. Dispose of this unit in accordance with local regulations. Dispose of the packaging materials, replace-
ment parts or equipment parts properly.
Dear Customer,
please refer to our terms and conditions common paradigm. In warranty cases inform your dealer directely and he will help you
due to country-specific legal claims.
g E n E r A l W A r r A n t y C o n D i t i o n S
