Step 3 - Assembling the sides
1. You can begin wiring now or during step 4
Use tie straps to keep wiring managed.
2.Place side panels in slots. See (*1) the tabs
on the side panels are placed into the slots.
(it should not but secure, just
place holders till next next)
G F1
F2
*1
6
3A
3A
E
E2
6
4
5
3B
-If you have a extra spacer panel (E2)
use screw (1B)
Use a screw driver if needed, to push screw
through the hole.
.
Step 5 Assemble Feet
X4
Step 6 Assemble Bottom Panel
Step 7 - Cover the bottom
1. Place bottom on top of
assembled enclosure. LIne up the holes
and screw it in with a screw driver.
Finished
1. If you do not
have the bottom spacer
panel (E2) still proceed
to install feet without
it.
1A
D
*1
*2
Notice
Countersink hole
on top. Screw will be
flush to the panel.
Step 4 - Assembling the box
1.Place the window’s (D) slots
into the tabs of the side panels
to keep the side panels in place
See (*2)
Make sure all side panels are in its tabs (top and btm)
before inserting the screw through window (D) to the pillar
See (*1)
2. you can wire at this stage as well, a bit harder with
the window on.
