7
ShowCUBE™ DMX RGBWA+UV Eternal Lighting
Updated 01/2015
Master/Slave
- Have one fixture in Master Mode and the rest of the fixtures in Slave Mode.
Turn on the Receiver button and put all fixtures on same ID Code Color. You now control
only the Master fixture and all the Slave fixtures will do what the Master is doing. The
Master fixture Wireless Indicator will start blinking RED (meaning transmitting signal) and
all the Slave fixture(s) will start blinking GREEN (meaning receiving signal).
Helpful Trick
: To Master Reset the
ShowCUBE™ DMX RGBWA+UV
to Factory setting, press
Menu and Enter button at the same time and hold for 5 seconds. The light will go into the
following factory settings. Color 1 Red, DMX Address back to 001, Channel mode back to
6CH Mode, Slave Mode, IR Disabled, Display on for 60 Seconds, Manual Colors back to 255,
and put all custom colors (A-E) back to 0 color settings on all RGBWA+UV.
Infrared remote control
: (Remote is Sold Separately)
To use the IR remote control on the
ShowCUBE™ DMX RGBWA+UV
, first ENABLE the IR INFA
located in the MENU selection. Also, turn the fixture into a MASTER. To control the fixture
you must aim the remote at the infrared sensor located by the Display (front and back of
fixture).
ShowCUBE Master/Transmit to Uplights to create Chase/Auto/Fade Programs:
Set the ShowCUBE to Master Mode
Enable the IR Mode on the ShowCUBE
Set the ShowCUBE to Address 001
Set the ShowCUBE to 6 Ch Mode
Be sure the ID Code Selector is the same on Master light as well as all other lights
that are the slaves. (See instructions about ID Code Selector above)
All CUBEecho/EchoICON/EchoEDGE/EliteParHEX (or any fixture that has a Native
6ch RGBWA+UV as Master Dimmer control Modes) – The lights must all be in 6 Ch
Mode.
In Series address each group of 10 lights as follows.
Address 001, Address 007, Address
013, Address 019, Address 025, Address 031, Address 037, Address 043, Address 049 and finally
Address 055.
Point the IR Remote to the ShowCUBE IR Sensor and Select a Program/Fade Mode from the IR
Remote. / Or on Push Button Display and Select the Program and Speed Setting you want to use.
Now you are connected from the ShowCUBE to your Uplights. The ShowCUBE is transmitting to
the Uplights as a Master to control the Uplights with amazing light shows, chases, programs and
patterns.
