Installation and Safety Manual of CIGS-3000A1&E1 Solar Photovoltaic Module
This document and all information contained herein is the sole property of ETERBRIGHT SOLAR CORPORATION and shall not be distributed, reproduced, or
disclosed in whole or in part without the prior written consent of ETERBRIGHT SOLAR CORPORATION.
A3-224
1.
Introduction
This manual provides information regarding the installation and safe handling of the
ETERBRIGHT SOLAR CORPORATION CIGS solar photovoltaic module. ALL of the instructions
in this manual should be read carefully before attempting installation. If there are any
questions, please contact ETERBRIGHT SOLAR CORPORATION
Technical Service department
for further explanation.
Please retain this manual for your future reference.
2.
Disclaimer of Liability
Because the use of this manual and the conditions or methods of installation, operation,
use and maintenance of photovoltaic product are beyond ETERBRIGHT SOLAR
CORPORATION’s control, ETERBRIGHT SOLAR CORPORATION does not accept responsibility,
and expressly disclaims liability for loss, damage, or expense arising out of, or in any way
connected with, such installation, operation, use or maintenance.
No responsibility is assumed by ETERBRIGHT SOLAR CORPORATION for any infringement of
patents or other rights of third parties, which may result from the use of the PV product.
No license is granted by implication or otherwise under any patent or patent rights.
If you do not adhere to the instructions given in this manual, your rights under the
ETERBRIGHT SOLAR CORPORATION warranty may be forfeited.
ETERBRIGHT SOLAR CORPORATION reserves the right to change the manual, the PV
product, the specifications, or product information sheets without prior notice.
3.
General Information
Installation should be performed only by qualified persons. Before installation, installers
should assume the risk of all injuries that might occur during installation, including, but not
limited to, the risk of electric shock. Installers must conform to all safety precautions in the
manual when installing modules.
4.
Warnings and Cautions
4.1 Warnings
One individual module may generate DC voltages greater than 30 volts when exposed
to direct sunlight. Contact with a DC voltage of 30V or more is potentially hazardous.
Installers should know in advance that the risk of injury may occur during the
installation, including electric shock.
All PV modules should be installed according to all local and national applicable
standards, codes and regulations.
Rooftop installations should be placed over fire resistant roofs ONLY.
