408-10243
Rev
E
3
of 5
3. Hold the tool so that the back (wire side) is facing you. Squeeze tool handles together and allow them
to open fully.
NOTE
Make sure the wires are bottomed in their respective wire slots prior to the crimping procedure.
4. Insert the assembly into the lower jaw of the hand tool. Locate the module and crimp. See Figure 4.
Figure 4
5. After termination, slide the shell over the module assembly and bottom. In order to ensure that the
shell is oriented properly for placement in the crimping tool, make sure the shell seam is opposite the
plug latch prior to insertion of the plug body. See Figure 5.
Figure 5
6. Insert assembly into the jaw of the hand tool and crimp.
NOTE
Make sure the cable jacket is located under the crimp area of the shell. See Figure 6.
Figure 6
Assembly Located
in Lower Jaw
Wire Side
Piercing of Contacts
Shell Seam
Shell
Terminated
Assembly
Assembly Located
in Upper Jaw
Crimp Shell
Terminated
