VG-5000 Administration and Set Up Guide Rev 01 Page 23 Essential Trading Systems Corp.
3.0 Sample
Configurations
3.1
Multicast channels to E&M ports
1. This procedure assumes, as the administrator of the VG-5000 system, you have
knowledge of the WAVE solution and have made the necessary configuration changes in
the WAVE Management server to accommodate support of the VG-5000 to be configured.
2. Using Internet Explorer, browse to the address of the VG-5000. After logging into the VG-
5000 and setting a static IP address, if applicable, click on the GATEWAY SETTINGS
heading (see Figure 4 Page 7).
3. Enter a Gateway Description. This is more for internal use and can be anything which
makes it easier to manage.
4. Enter Gateway Username. This must match the Username created in the WAVE
management server for this gateway.
5. Enter Gateway Password. This must match the Password created for the Username
created in step 4. Password is case sensitive.
6
Enter the IP address of your WAVE Management server. This is necessary so the gateway
knows where to fetch its core configuration from.
7. Click the “Get Profile & Zone” button.
8. Based on the Profile and Zone configured in the WAVE Management Server, the
respective information will populate in the respective windows below the button. If an
alternate zone and profile is desired, click the arrow button next to the respective category
and select from the available zone or profile presented.
NOTE: The VG-5000 is a SIP based product and therefore requires SIP configuration data
to be entered.
9. Enter the SIP Registrar Server IP Address. This address must match the IP address
assigned to the VG-5000 or calls will not be routed correctly.
10 Enter the SIP Registrar Server IP port. Default is 5070. This is for internal use and should
not be changed.
11. Enter SIP Registrar Server Expiration. Default is 30. This is for internal use and should
not be changed.
12. Click the “Submit Settings” button at bottom of page then click the COMMIT CHANGES
heading at the top of the webpage to activate the changes.
13 Next, hover your mouse over the CHANNELS heading at the top of webpage and select
LOCAL CHANNELS from the drop down menu (see Figure 6 Page 9). You should see a
list of the Hoot channels fetched from the management server during step 7. above.
14. Under “Gateway Interfaces” note the ports listed, Ports 1-4 represent the four 4-wire E&M
ports on the back of the gateway. Click the button next to each port and select the Hoot
channel you wish to assign to that E&M port.
15. Click the “Update Port Assignments” button when finished assigning Hoot channels to E&M
ports.
16 Next click on a Hoot from the Channel List to edit its properties.
17. Enter a dial in number and a dial out number. These can be any arbitrary numbers much
like a PBX extension. These allow hoot channels to be accessed from other SIP endpoints
and for automatic connection to T1/E1 channels. If additional VG-5000’s will be deployed
across your network be sure assign different dial in/dial out extensions to each gateway.
18. Check the Auto Ring Down Trunk option if the respective Hoot channel will be
automatically connecting to an E&M channel of a T1/E1. If not applicable, leave the box
unchecked.