ETC Source Four XT HID Zoom 15-30, Руководство пользователя

Страница: 5 / 20

3
Replacing the HID Lamp
A lamp must be installed before you use the fixture. The lamp can be replaced without affecting the
focus.
Step 1: Ensure power has been disconnected and the lamp is cool before replacing the lamp.
Step 2: Loosen the screw securing the ballast.
Figure-2 Ballast and Reflector Housing Base on the Back of the Fixture.
Step 3: Rotate the ballast to reveal the lamp cap.
Step 4: Loosen the four screws of the lamp cap.
The screws are captive so they will stay in the cap.
Step 5: Pull the lamp assembly straight out of the fixture.
Step 6: Carefully pull the old lamp out of the ceramic base.
Step 7: Holding it by the base, remove the new HID lamp from its box.
W A R N I N G :
Do not replace the lamp when it is raining or snowing. Do not stand in water
while replacing the lamp. Failure to follow this warning can result in serious
injury or death.
W A R N I N G :
Disconnect power and let the lamp cool before replacing.
N o t e :
Verify that the HID lamp you intend to install is suitable for your fixture’s ballast.
See Lamp and Ballast Information, page 2 . Operating HID lamps above their rated
voltage reduces lamp life and can cause premature lamp failure.
The facility’s voltage must match the voltage of the fixture and its ballast.
Blast screw
Rotate ballast
Lamp cap