ETC Setup and Connect Guide
Paradigm 18 inch Touchscreen
P-TS18 Touchscreen
Page 3 of 15
ETC
Rack Mounting
The P-TS18 Touchscreen Rack Mount Kit (P-TS18-RK) provides the ability to install the P-TS18 into a 19”
rack, utilizing eight units (8U) of rack space.
Installations
1:
Locate the P-TS18, the accessory box from the P-TS18 packaging, and the P-TS18 Touchscreen Rack
Mount Kit.
2:
Using the included locknuts, mount the power supply holder with the power supply installed to the
back of the rack mount panel using a 5/16 nut driver.
3:
Attach the rack mount panel to the 19” rack enclosure using the four M10 screws, washers, and the
spring clips provided with the Rack Mount Kit.
4:
Carefully remove the plastic trim ring from the back of the touchscreen.
Note:
Full access to the front and back of the equipment rack is required during this installation
procedure.
Note:
The P-TS18 ships with a table top stand which is not required when rack mounting.
Recycle or discard the unused stand parts.
Install
Locknuts
