ETC ColorSource Spot Pearl v1.7, Руководство по установке

Страница: 6 / 16

ETC Installation Guide
ColorSource Spot Pearl v1.7
Set Up the Fixture
1. Plug the power cord into the powerCON In connector on the rear of
the fixture.
2. Make any power-thru cable connections prior to applying a power
source.
3. Make any DMX connections, and if the fixture is the last in a DMX line,
terminate the fixture. See
Connectors on the previous page .
4. Plug the power cord into the power source.
Data in Data thru
Mode Up and Down
User interface
Power
in
Power
thru
Safety cable
attachment
loops
Power Up
Press any button to wake the display. The display shows the DMX address.
See
Set the DMX Address below .
You can press the Mode button to access the Presets menu. See Play Presets
on page 10 .
Adjust the Tilt
The fixture can be tilted up and down and rotated (panned) as needed.
1. Loosen, but do not remove the yoke locking knobs.
2. Tilt the fixture to the desired angle.
3. Tighten the yoke locking knobs.
Set the DMX Address
1. Press any button to wake the display. The display shows the DMX
address.
2. Use the Up and Down buttons to select the DMX address for the
fixture.
You can also use RDM for DMX addressing. See RDM Values on page 13 .
ColorSource Spot Pearl Page 6 of 16 ETC