ETC Installation Guide
D1 & D2 Series Drivers
D1 & D2 Series Drivers
Page 16 of 25
ETC
Mount the Driver
Depending on your installation, you might want to surface-mount the driver. Any ArcSystem
standalone driver can be surface-mounted to any surface capable of supporting its weight using the
four holes located on the back side of the enclosure. Contact ETC for custom mounting bracket
options.
1. Remove the two screws on the cover of the driver and set them aside.
2. Remove the driver cover. The cover is tethered to the backbox. Be careful when handling.
Note:
If you are installing a D1 High Output driver, the power supply is inside the cover
and has wiring that runs to the driver board in the back panel of the driver. Be careful when
handling. It may help to nest the back panel of the driver inside the cover as shown in
3. Using four #10 screws, mount the back panel to the mounting surface.
4. Attach flexible conduit to the driver. There are four conduit knockouts available.
5. Install Romex or nonmetallic screw-clamp conduit connectors to output knockouts, as needed.
Note:
Make sure that the flexible electrical supply can extend through the ceiling
opening so that the driver and luminaire can be inspected and serviced when needed.
Note:
Use suitable conduit where required by national and local codes.
Note:
Drivers may require additional means of securement. Installation must follow all
national and local codes for electrical equipment.
Emergency System One-Cell Installation
With the exception of power input terminations, ArcSystem emergency system installation
requirements are the same as those of the standard ArcSystem. Complete the appropriate steps for
your installation, referencing the following sections for any additional installation details before
wiring the power:
•
Preparing the Ceiling for Recessed Luminaires on page 8
•
Installing One-Cell Recessed Luminaires on page 10
•
Installing One-Cell Yoke-Mounted Luminaires on page 11
•
Prepare to Install the D1 or D2 Series Driver on page 11
•
•
