Etatron eSelect-CD1, Инструкция по эксплуатации и техническому обслуживанию

Страница: 10 / 36

10 ENGLISH
Caps (A) x 4
• The electrical installation must comply with the standards and rules in force in the country where it is utilised.
• Use of electrical equipment always implies observance of some basic rules:
1 - Do not touch the equipment with wet or damp hands or feet;
2 - Do not operate the equipment with bare feet (example: swimming pool equipment);
3 - Do not leave the equipment exposed to the action of the atmospheric agents;
4 - Do not allow the equipment to be touched by children or used by unskilled individuals without supervision;
• When commissioning the unit or in case of emergencies or improper functioning, the controller should be switched off
immediately. Disconnect the power cable from the main power supply! Contact our technical assistance for any necessary repairs,
use only original spares! Failure to respect this condition could render the equipment unsafe to use.
• When carrying out any repairs or opening the unit, ensure to disconnect it from power supply.
• When there is no longer use requirement of installed equipment, ensure to disconnect it from power supply.
1. Disconnect power from mains or from the single-pole switch-contact.
2. Take all due safety precautions during unit service (gloves, goggles, overalls, etc.).
Assembling and dismantling the equipment
ASSEMBLY: all ETATRON D.S. controllers are fully assembled. For the wall mounting, please proceed as follows.
DISMANTLEMENT: before dismantling the unit or carrying any operation, disconnect power.
ESELECT-CD1 SERIES ENCLOSURES, MOUNTING, COMMISSIONING AND OVERALL DIMENSIONS
Wall mounting enclosure eSelect-CD1
eSelect-CD1 enclosure ABS plastic 200w x 106h x 90,5d
To access the 4 wall mounting points remove the 4 mounting point closures (A) located in each corner of the controller.
The enclosure features 4 captive screws for a quick opening/closing of the lid thus allowing easy access for commissioning and
service and also guarantees a perfect seal for long time operation
a. - Install the unit in a dry place and well away from heat sources; max environmental temperatures 40°C.
b. - Carefully observe regulations in force in the various countries as in regards electrical installations.
c. - Mount the controller on the wall using the screws and dibbles provided with the unit
VERY IMPORTANT NOTE FOR ENCLOSURE: when handling the unit bear in mind not to pull, drag, or mistreat the flat cable
connecting the pcb display placed on the lid with main pcb.