ETAS
Installation
FETK-S2.1 - User’s Guide
27
5
Installation
In this chapter, the hardware installation of the FETK-S2.1 is described.
5.1
Connection to the ECU
For connecting the FETK-S2.1 to the ECU two FETK adapter cables are recom-
mended:
• at CON1 adapter cable ETAM8
• at CON2 adapter cable ETAM2 or ETAM5
For additional details to connect the FETK-S2.1 to the ECU with adapter cables
see Fig. 5-2.
The adapter cables are to be ordered separately (refer chapter “Ordering Infor-
mation” on page 63).
Fig. 5-1
FETK-S2.1 Connection to the ECU
CAUTION
Some components of the interface board may be damaged or destroyed by
electrostatic discharges. Please keep the board in its storage package until
it is installed.
The board should only be taken from its package, configured, and installed at
a work place that is protected against static discharge.
CAUTION
Risk of short circuiting the internal signals of the FETK!
When you mount the FETK to the ECU, you must ensure that the screws and
washers used will not penetrate the FETK printed circuit board.
ETAM2 or ETAM5
FETK-S2.1
ETAM8
