Installation and Configuration for Windows 9x
10
3.3
1. Plug in the new card and switch on the PC.
Normally, Windows 9x automatically detects
your network adapter. If the automatic detection
does not work, choose a new network adapter
manually.
2. To do so, double-click the
Hardware
icon in the
Control Panel
window (
Start
→
Settings
→
Control Panel
).
3. Choose the appropriate driver for your card from
the disk or CD-ROM supplied by the manufac-
turer. Additionally, the disks or CD-ROM of Win-
dows 9x may be needed.
4. Check the settings for the new network adapter,
especially for address conflicts and the NDIS ver-
sion used.
5. Restart your PC.
6. To install an additional network adapter card
(e.g. to connect to a LAN), repeat the steps
above.
Please beware of possible address conflicts between the two adapters - identi-
cal interrupts are allowed with PCI-bus adapters or PC cards.
The correct settings for the configuration of the network adapter card (TCP/IP
protocol, bindings, etc.) are given in the next section.
3.3
Configuring the Network Adapter
To access the network settings, choose
Start
→
Settings
→
Control Panel
and double-click the
Network
icon.
1. Select the network adapter card for the ES1000
from the list of installed network components
(
Configuration
tab) and click
Properties
.
note
The NDIS version in Windows 9x must not be
higher than 4. Set the option ’NdisVersion to ’Ver-
sion 4’ or below (not ’AUTO’) (see 2. on page 11)
ES1000-Ethernet-ug-en.book Seite 10 Freitag, 19. Januar 2001 5:12 17
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
