4
Under
-in
f
lation:
DO NOT USE an under-in
f
lated product.
Insufficient
inflation or loss of
mattress
air may cause lack of body support. It is
important that you are immersed into the
mattress
, but not resting on the
base or bottom of the
mattress
, as it can result in peak pressure areas.
Prolonged exposure to peak pressures could increase risk of breakdown to
the skin and other soft tissue.
Over-in
f
lation:
DO NOT USE an over-in
f
lated product
. If the support
surface remains over-inflated for daily use, the body will not immerse into
the cells, which may reduce or eliminate the product’s benefits, and
increase risk of breakdown to the skin and other soft tissue.
Climate:
If the product has been in temperatures less than 32°F / 0°C and
exhibits unusual stiffness, allow the product to warm to room temperature.
Then, knead the air cells with your hands, or roll up the product and then
unroll it (with the valve open until the neoprene is soft and pliable again.
Repeat proper adjustment instructions before using. Avoid extreme heat
and keep away from heat sources, hot ashes, or open flames.
Pressure:
Changes in altitude may require you to readjust your product for
proper inflation. Check inflation each time you change altitude.
Puncture:
In order to prevent your product from being punctured, keep it
away from sharp objects.
Handling:
DO NOT attempt to carry your product by the valve(s or pull the
product by the valve(s. Lift underneath the base of the support surface
section to carry.
Obstructions:
DO NOT place any unneeded obstructions between the user
and the support surface, and use as few linens as necessary, as this may
reduce or eliminate the product’s benefits and increase the risk of skin or
soft tissue breakdown.
Instability/Fall Hazard:
DO NOT use your product in conjunction with, or
place on top of any other products or materials, except as listed in the
Intended Use section.
This may result in instability and/or falls.
Oil-Based Lotions:
Do not let oil-based lotions or lanolin come into contact
with the product, as it may degrade the neoprene.
Sunlight:
Prolonged exposure to sunlight or ozone can degrade the
neoprene and may lessen the effectiveness of the product.
