CAUTION
– Do not use any aggressive washing or cleaning agents or hot water to clean the HEPA
filter and the micro-filter.
– Cleaning the filter will not restore its original colour, but it will restore its filtration
properties.
– The dust container is not resistant to cleaning in a dishwasher.
– The HEPA filter and the micro-filters are not intended for cleaning in a dishwasher.
– Proper insertion of micro-filters into the container will enable securing the mechanical
safety lock. Now you can put the container into the vacuum cleaner.
– The safety lock will not make it possible to put the container into the vacuum cleaner
if you forget to insert the micro-filters.
– Neglecting regular replacement of micro-filters can result in the vacuum cleaner defect!
– Make sure that the binding surfaces and sealing elements are functional.
– We recommend replacing the HEPA filter 2x a year. Replace the other filters if they
cannot be cleaned properly or if they are damaged. You can buy a spare HEPA filter
and micro-filters in the network of elektro shops.
Exhaust micro-filter
Push the lock in the lower part of exhaust cover
A10
, then lift off the cover and remove it
from the vacuum cleaner (Fig. 17). Pull out micro-filter
A9
. Put the new micro-filter back
to the vacuum cleaner in the opposite direction. Insert the lugs on the back cover into two
holes in the vacuum cleaner cover and snap the cover.
Storing accessories
Insert one of the accessories (upholstery nozzle
C4
, crevice nozzle
C6
) into holder
C7
that is then mounted on the suction tube. The remaining accessories, the floor nozzle, the
suction tubes and the hose can be dismantled or left assembled and hung on the back
side of the vacuum cleaner into the storage position. For better stability, slide individual
parts of the tube inside each other so that the tube is as short as possible. When storing,
always set the floor nozzle to the carpet position (i.e. with the brush retracted); thus you will
prevent bending of the bristles.
V. MAINTENANCE
Store the vacuum cleaner at a dry place, far enough from heat sources (e.g.
fireplace,
stove, heating element
) and protect it against weather conditions (e.g.
rain, sunshine
).
Treat surface of the appliance with a soft and damp cloth, do not use coarse and
aggressive detergents! Store the appliance properly cleaned at a dry, dust-free place out of
reach of children and incapacitated people.
Floor nozzle
It is recommended to check the brushes or collectors for possible impurities. If there are
some impurities, remove them.
Cleaning the TURBO nozzle C8
(pic. 19)
Cut the threads and hairs with scissors. Turn on the vacuum cleaner. The cleaner vacuums
the cut hairs and threads. In case hairs or threads got tangled up around the attachment of
the brush cylinder and cannot be removed with the above-mentioned steps, it is necessary
to remove them with a suitable tool (e.g. tweezers).
GB
23 / 39