Problem
Cause
Solution
Iron is not
heated.
Power supply not connected
Check the cord, plug and the socket
Thermostat regulation wheel is in MIN
position
Set the wheel to position • / •• / ••• or MAX
AUTO STOP function activated
Move the iron for deactivation of the safety function
Iron does not
create steam
There is no water in the container
Pour water into the container
Steaming regulator is in
0
position
Move the regulator into the steaming position
Low temperature is set for activating
the DRIP-STOP function
Use the regulation wheel to set a temperature,
during which you can use steaming and wait till
the iron is heated for using it
Iron does not
create steam
shock
Low temperature is set for activating
DRIP-STOP function
Use the regulation wheel to set a temperature,
during which you can use steaming and wait till
the iron is heated for using it
The function of steam shock was used
too often during a short period of time
Let the iron heat and wait for a while before
using the electric shock function again
Sprinkling
equipment
(additional
spray) does not
sprinkle water
There is no water in the container
Pour water into the container
The water system is aerated
Tighten finger on the additional spray jet hole
and at the same time press the sprinkling
device button several times
Water is
dripping from
the ironing plate
The lid of the pouring hole of the
container is not closed properly.
Close the pouring hole lid
The steam shock function was used
when temperature below ooo was set
Use the regulation wheel to set
a temperature ••• or MAX
The SELF CLEAN button was pre
-
ssed during ironing
Do not use the SELF CLEAN function
After finishing ironing, the iron was
put into the horizontal position and
the steaming regulator is not in
0
position
Move the steaming regulator to 0 position,
empty the container and put the iron into the
rest position
Flakes and other
impurities are
peeled off the
ironing plate
Contrary to recommendation
undiluted water is used with
excessive hardness
>15 °N
Use water diluted with distilled water
Clean the iron using the SELF CLEAN function
and steam shock
Brown liquid is
pouring out of
the ironing plate
Forbidden chemical agents have
been used to remove the limescale
or there is substantial amount of
limescale in the steam chamber and it
needs to be cleaned
Do not add any chemical agents into the water
container for removing scale
You use one of the types of water that
we do not recommend
Use only common clean drinking water for filling
in the container, or water diluted with distilled
water
Fibers from linen got into the holes in
the ironing plate and they are burning
there
Clean the iron using the SELF CLEAN function
and the steam shock, or vacuum the cooled
plate delicately from time to time
V. TROUBLESHOOTING
GB
29 / 50
