eta DIGI VIENTO 7284, Руководство пользователя

Страница: 26 / 76

Make sure that the power cord is not damaged and that it does not lead any sharp or hot surfaces.
The electric socket must be easily accessible so that the iron can be easily disconnected from
power supply if danger appears. At first switch the iron ON to maximum temperature and let the
iron at least 10 minutes running without water . The iron may produce slight smoke, which is
cased by burning of used lubricants and seals in steam chamber. This is normal situation and
does not form the reason for warranty claim. During first filling of the tank with operating water it is
recommended to release the steam from whole tank outside the ironed fabric.
Ironing temperatures
– Sort laundry and iron according to the instructions for treatment (e.g. manufacturer’s
recommendation - the label on clothes ). If the instruction is missing and you know the
material of the clothes, follow the table on picture 3. The table applies to basic materials only,
not to possible decorations, material treatment, etc.
– Start to iron from the lowest temperatures to higher temperatures. If clothes consist of e.g.
two and more materials or if they contain stringing, purls, embossing, stretch material
,
etc., always iron according to the material requiring the lower temperature only. If you do not
know the material, find the suitable place that is not visible when wearing and try suitable
temperature for ironing at the place.
– When ironing woollen fabrics, we recommend ironing on the back side of the fabric and you
can iron virgin wool through additional cloth. Velvet and similar fabrics can be ironed in one
direction ( you will prevent creation of glossy areas ).
– Steam ironing is not suitable for fabrics from synthetic and silk fibers (e.g. acrylon, nylon,
polyamide, spandex, elastan, or polyester ).
– We recommend using soft textile permeable base materials for steam ironing.
– Make sure that the ironed fabric is tensed up properly so that steam does not leak to the sides.
– For the ironing plate A to remain smooth, protect it from direct contact with sharp metal
objects (e.g.
zip fasteners, buttons, snap buttons, decorative objects
).
Control
– Plug the power cord
M
to a socket. You will see the
ETA VIENTO
sign on the display, thenthe
iron is switched automatically to the stand-by regime and the STAND-BY sign is shown on
the display.
– Set the selected H program (i.e. the fabric material) using the control. By turning the
knob repeatedly to the right (i.e. in the clockwise direction), you set the programmes from
SYNTHETIC to LINEN , which means you are increasing the temperature. By turning the
knob repeatedly to the left (i.e. anti-clockwise), you set the programmes from LINEN to
SYNTHETIC , which means you the are reducing temperature.
– The respective information is shown gradually on the display using signs and symbols (fig. 9)
STAND-BY SYNTHETIC AKRYLATE sIlk WOOL CoTTN JeANs
lINeN .
– Increasing ( ) or reducing ( ) the temperature is signaled by a flashing symbol.
– Reaching the proper temperature is signaled by the TEMP.OK sign and a sound signal.
Sound signaling
– Every pushing of the control H in requirement for setting the fabric material = “1 very short beep”.
– Every pushing of the control (i.e. change of the program) = “1 short beep”.
– Reaching the temperature of the set program = “1 long beep”.
– Activation of the safety function AUTO-STOP = “permanent beeping”.
Note : when setting the STAND-BY program, every other pushing of the - control is without any
effect.
26
GB
/ 74