eta aqua care+ 1708, Инструкция по эксплуатации

Страница: 19 / 44

III . INSTRUCTIONS FOR USE
Remove all packaging materials, take out the oral irrigator and any accessories. Put the appliance on
a flat and dry surface (so that it cannot fall into water), out of reach of children (see sec. I. SAFETY
INSTRUCTIONS). Use the appliance with the connected power USB cable other USB charger or mobile
power.
WARNING
– Do not use USB ports on other devices (e.g. computers, laptops, tablets, mobile phones,
etc.) to power the appliance. Such devices may not be dimensioned for the current
consumption of the appliance and it could damage them.
Charging of accumulator
Turn off the appliance before connecting it to the supply chord! Connect the enclosed USB cable G to the
power supply terminal A6 , and connect the other side to a power source, for example to a compatible AC
power adapter, or to a backup power source. The first charging or charging after a long period of time is
approx. 4 hours! On the oral irrigator A , charging is indicated by the bottom indicator A2 flashing; when fully
charged, this indicator is on continuously.
Caution
– Do not exceed the recommended time of charging 4.5 hours during regular charging!
– The charging base also serves as a stand where you can place the oral irrigator and nozzle after
use. However, do not connect the base to the mains unless you wish to charge the appliances. Do
not leave the charging base connected to the mains permanently! temperature, age, method of
charging, etc.
– The operating times are only approximate. The time depends on the condition of the battery,
ambient temperature, age, method of charging, etc.
IV . USE (pic. 2, 3)
The water system must be flushed out before first use. Fill the water reservoir
C
with clean drinking water
according to the following instructions, re-assemble the appliance and switch it on. Allow all the water to
run through the oral irrigator to the washbasin. Repeat this procedure at least twice.
Assembly/disassembly of the individual components
Water reservoir C – to remove the water reservoir from the charging base A , pull it upwards. Pour
water into reservoir (do not exceed the 500 ML mark). If the water feels cold, use lukewarm water with
a temperature of 40 °C or less. Re-attach the reservoir to the charging base A in the opposite way.
Place the cover
C2
onto the reservoir.
Holder B4
– Slide on the desired holder
B4
on the hole
A4
with a slight push and turn it clockwise till
you hear a click.
Caution: check whether the holder is put properly on its place in the
base and is not leakage of water.
Attachment D, E, F
– the desired snozzle into the opening at the top of the oral irrigator body
B
until
it locks in place (you will hear a click). “Pull” the attachment slightly so as to check that it is properly
fitted. To remove the attachment, press the ejector button
B2
first and take out the attachment pulling it
gently.
Nozzle D – cleaning the space between the teeth, Direct the water flow onto the zone between
the teeth.
Nozzle E – cleaning the front of the teeth.
Nozzle
F
– Periodontal pocket cleaning. Slowly shift the water flow along the gum. Gently stimulate the
areas of concern.
Select the water pressure with the pressure control dial A3 ( = gentle, = strong). We recommend
that you start with setting , especially if your gums tend to bleed or if children are using the irrigator.
mode
– minimum/gentle for sensitive teeth, gums and for periodontal pocket cleaning,
mode – standard/intensive for regular cleaning of healthy teeth and gums,
mode – maximum for cleaning of healthy teeth and gum care.
GB
19 / 39