EN
EN - 89
VI. TURNING ON THE APPLIANCE
Saving energy
•
Pre-rinsing of tableware items leads to increased water and energy consumption
and is not recommended.
•
Washing tableware in a household dishwasher usually consumes less energy and
water in the use phase than hand dishwashing when the household dishwasher is used
according to the instructions.
Starting a cycle wash
1. Draw out the basket, load the dishes and push them back.
2. Pour in the detergent (see the section e`ntitled Salt, Detergent and Rinse Aid).
3. Insert the plug into the socket. The power supply is 220 – 240 V AC / 50 Hz, the specification
of the socket is 10 A 250 V AC. Make sure that the water supply is turned on to full pressure.
4. Close the door, press the ON/OFF button, and the ON/OFF light will turn on.
5. Press the program button. If a program is selected, the response light will light. Then
press the START/PAUSE button, the dishwasher begins to wash.
WARNING!
When you press the START/PAUSE button to pause during washing,
the program light will stop blinking and the dishwasher will mooing every
minute unless you press the START/PAUSE button to start.
Change the Programme
•
You can modified the washing program, just the dishwasher has been running for a short
time. Otherwise, the detergent may have already been released, and the appliance may
have already drained the wash water. If this is the case, the detergent dispenser must be
refilled (see the section entitled “Loading the Detergent”).
•
Press the
Start/Pause
button to pause the washing. Press Program button for more
than 3 seconds - the program will cancel. Press the Program button to select the desired
program. Press the
Start/Pause
button, after 1 seconds, the dishwasher will start.
3 sec
NOTE
If you open the door during a wash cycle, the machine will pause. The program light
will stop blinking and the buzzer will mooing every minute unless you close the door.
After you close the door, the machine will keep on working after 10 seconds.
•
If your model has broken remember function, the machine will go on to finish the
selected program afterthe powercut.
