eta 0568, Инструкция по эксплуатации

Страница: 27 / 60

Remote control
– Remote control unit C may also be used to switch between modes and functions. The
appliance response is the same as when controlled by buttons on the control panel B .
– Aim the remote control unit at the front side of the control panel B .
– Proceed according to Fig. 2 to replace battery (3V CR2025).
– If you are not going to use the appliance for a longer period of time, take out the
batteries.
– Keep battery out of reach of children and incapacitated people. A person, who would
swallow the battery, must seek medical help immediately.
– If the battery are leaking, take them out immediately, otherwise they may damage
the appliance.
V. MAINTENANCE
Wipe the individual parts of the appliance’s outer casing, including the control panel with
a damp cloth or sponge. Prevent water spilling inside the appliance or control panel.
Do not use any aggressive or abrasive cleaning agents.
Pad cover and cooling pad
Do not remove the rear cover of A11 pad during normal operation. Remove it only if you
are going to replace the cooling pad A10 (its service life is up to 3 years under normal
operation), or to make a complete maintenance after the respective period of time.
Unscrew two A14 screws to dismount the cover. Then remove the cooling pad according to
Fig. 1. Clean the cover and the pad by a fine brush and water with a neutral cleaning agent
added, then rinse in clear water and let dry. Wipe the internal parts of the appliance under
the cover with a damp cloth only. Assemble both parts using the reverse procedure, and
put them back inside the appliance.
Warning
– Once the cover is reinstalled, do not forget to properly fix it by tightening the screws
A14
and to secure it by the cover arresting lock
A13
.
– Never insert any items or fingers in the internal section under the cover (behind the
plastic grid)! Also pay an increased attention when handling water while the cover is
removed.
Water tank
The tank may be cleaned for example by a fine brush and cloth after taking the tank
out from the cooler body, or you may remove it completely and perform a thorough
maintenance. However to do so, you have to release A9 pump arresting lock according
to Fig. 1. To avoid pinching the pump hose and cable, lead them though the cut hole
according to the detail of Fig. 1.
27
GB
/ 55