– 9 –
ETAsys.com
Specifications are subject to change without notice.
1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.
Telephone: 800-321-6699 • Fax: 800-996-3821
ETA-S20RT
AC Distribution & Suppressor Unit
INSTALLATION
Before installing, it is recommended to read the entire manual to ensure proper operation and that all features are being utilized. The
ETA-S20RT can be placed on a shelf or rack mounted in a standard 19" width rack. When rack mounted, placement within the rack is
flexible however the ETA-S20RT should be within 6' of a dedicated 20A AC outlet. When rack mounting, use Rack Rail type screws of
10
⁄
32
" x 1". Always make sure the 20A outlet is properly inspected by a certified electrician prior to connecting the ETA-S20RT. Make sure
to inspect the equipment that will be connected to the ETA-S20RT to ensure it does not exceed 20A total amperage draw.
Remote Activation Connections Diagram
Remote Activation via Hard Contact Switch
Use External Key or Panel Switch, Hard Contact
To Remote Panel LED, Use the +12 and GND Terminals.
Note:
Use a 2K ohm
1
⁄
8
W Resistor In Series with +12VDC and LED
Remote Voltage Activation
Apply +5V–24VDC and Connect a Ground to the GND Terminal
to Activate the Unit.
Note:
It is OK to Have Two Wires In the Same Terminal.
To Remote Panel LED, Use the +12 and GND Terminals.
Note:
Use a 2K ohm
1
⁄
8
W Resistor In Series with +12VDC and LED
