Et ET-M660BH BB Series, Руководство по установке

Страница: 4 / 16

www.etsolar.hk
- 1 -
WARNING!
The photovoltaic module produces electricity when exposed to the sun or other
light sources. For your safety and the safety of others, please read the entire
installation and assembly instruction manual carefully prior to installation. Please
carefully read the following installation and safety instructions. Non-compliance
with these instructions may void the module warranty.
1
Introduction
This guide contains information regarding the installation and safe handling of ET
Solar photovoltaic modules (hereafter referred to as "modules"). All instructions
should be read and understood before attempting installation. If there are any
questions, please contact your dealer or ET Solar for further information. The installer
should conform to all safety precautions in the guide when installing modules.
Before installing a solar photovoltaic system, the installer should become familiar
with the mechanical and electrical requirements for photovoltaic systems. Keep
this guide in a safe place for future reference. If not otherwise specified, it is
recommended that the requirements of the U.S. National Electrical Code (NEC) or
respective European Code and other countries Code be followed.
Non-compliance with this installation instruction may result in property
damage and/or physical injury. ET Solar will not be liable for compensation of any
loss or injury caused by this type of non-compliance.
2
Codes and regulations
The mechanical and electrical installation of PV systems should be performed in
accordance with all applicable codes , including electrical codes, building codes
and electric utility interconnection requirements. Such requirement may vary for
mounting location. Requirements may also vary with system voltage,and for DC or
AC application. Contact local authorities for governing regulations.
3
General information
Be careful when unpacking, transporting, and storing the modules. They are subject
to breakage if they are not handled and installed properly. It is recommended not
to take them out of the packaging until the moment of the installation. During
installation, please use soft materials to protect the modules from contacting
directly with the ground, concrete or tiles. Otherwise scratches or glass breakages
may occur.

Installing solar photovoltaic systems requires specialized skills and knowledge.
The installer assumes all risk of injury, including risk of electric shock. Module
installation should be performed only by qualified persons.

All modules come with permanently attached junction box and 4 mm² (#12
AWG) wire terminated in PV connectors. Your dealer can provide additional