GB
OPERATING INSTRUCTIONS
PD-C180i KNX ECO
EP10426452
PD-C180i KNX ECO DK
EP10426476
PD-C180i KNX ECO CH
EP10426490
www.esylux.com
3 /6
DECRIPTION OF THE APPLICATION
1. MASTER/SLAVE
The Master detects presence and processes it according to
set parameters.
“Lighting ON/OFF”
The Slave is used exclusively for extending the field of detection.
Presence is transmitted to the Master (object 18) for processing
according to the set parameters.
• Master/Master selection
Two Masters can work in parallel to extend the field of detection.
Each Master processes the presence (objects 18 and 20, if applicable 21)
according to its parameters set via the ETS (Engineering Tool Software),
and controls the lighting appropriately.
Default setting: Master
2. TEST MODE
(Only for Master device configuration)
During test mode “ON”
light measurement deactivated.
When test mode is enabled, the connection with the lighting system is
checked.
Depending on the parameter settings, in the event of detection via the
motion sensor or microphone, the lighting will be “ON” for 5 seconds
followed by a dead time of 5 seconds “OFF”.
The blue LED indicates motion detection, the red/green LED indicates
detection via the microphone whereby the red LED indicates a noise well
beyond the limit value and the green LED a noise just above the limit value.
Test “ON” automatically switches to test “OFF” after 10 minutes or when
the parameters are stored.
NB: During test
Slave input enabled.
3. BEHAVIOUR AFTER ETS DOWNLOAD/DEVICE RESTART
The choices include: “No reaction”, “ON”, “OFF”
In the process, the following objects are sent:
Switching operating mode:
- Object 4: “Output: light channel 1 ON/OFF”
- Object 5: “Output: light channel 2 ON/OFF”
- In addition, object 17: “Output: HVAC channel ON/OFF”
4. REMOTE CONTROL
Operation is deactivated with Mobil-PDi/User or X-REMOTE (iphone).
Note: Remote control deactivated in test mode.
