OPERATING INSTRUCTIONS
PD-FLAT 360i/6 mini DALI
PD-C 360i/8 mini DALI
GB
17 / 20
Twilight switch mode:
In twilight switch mode, the detector acts as a twilight switch. The function can be
activated by pressing the “Unlock” button. Then keep pressing the C1 button until
the
blue LED flashes three times. As soon the “Lock” button is pressed, the detector is
operating in twilight switch mode.
The standard switching value is 50 lux. However, the light values specified on the
remote control can also be selected, or the current light value can be read and stored
using the “Eye button” on the remote control.
The switch-off value is always twice the target value. With a switching value of 50 lux,
the detector switches on if the lighting level falls below 50 lux and only switches off
again if the lighting level exceeds 100 lux. To prevent the detector from responding
to every lighting change in the limit range, the dark to light time delay is fixed at five
minutes.
In twilight switch mode, the detector does not respond to any connected DALI
buttons.
The connected lighting is always corrected to 100 % in this mode when switched on.
Function
Customised setting
Enter programming mode
The detector goes into programming mode.
Acknowledgement:
The
blue LED
lights up permanently and the lighting is
switched on continuously.
Press button C1
Exit programming mode
The set parameters are stored on the detector.
Acknowledgement:
The
blue LED
is switched off.