OPERATING INSTRUCTIONS
13 / 17
GB
MD 360/8 Basic
MD 360i/24 Basic
MD 360/24 Basic SMB
MD 360i/8 Basic
MD 360/8 Basic SMB
MD 360i/24 Basic SMB
MD 360/24 Basic
MD 360i/8 Basic SMB
6.8
Programming the Mobil-PDi/MDi-universal
Programmed values are applied permanently.
1.
Select the sub-item
“
Channel 1
”
in the
“
PDi/MDi
”
menu.
PDi/MDi
Remote control
Functions
Channel 1
Channel 2
System
Bat ok
LS
MDi
2.
Then press the
button
to enter programming mode.
Acknowledgement:
The
red
LED
lights up permanently and the lighting is switched on continuously.
3.
Press the
button
to exit programming mode.
Acknowledgement:
The
red LED
is switched off.
Function
Customised setting
Functions
ON/OFF
Test
Reset
4 h ON/OFF
Bat ok
LS
MDi
Take a reading of the current ambient light value
The detector switches the lighting on if the target brightness value is below the preset
lux value and movement is detected in the field of detection.
Acknowledgement:
The
red LED
and the lighting are switched off for approx. 5 seconds
while the reading is taken.
Channel 1
Read-in
Light
Time
Reset
LEDs ON/OFF
Fully/semi-automatic
Bat ok
LS
MDi
Light
400 Lux
Bat ok
LS
MDi
Set the brightness switching value
Setting values:
10, 100, 250, 400, 600, 800, 2000 lux
The detector switches the lighting on if the target brightness value is below the preset
lux value and movement is detected in the field of detection.
Acknowledgement:
The
red LED
flashes three times in cycles if the selected brightness
switching value has been confirmed using the
button
.
