ESX Xenium XE4240-DSP, Руководство пользователя

Страница: 27 / 36

27
HIGH LEVEL
INPUT
E / F / G / H
LINE OUT
SPEAKER
OUTPUT
BATT.
+12V
GND
XE4240-DSP
4-CHANNEL AMPLIFIER WITH
DIGITAL SOUND PROCESSOR
POW.
PRT.
REMOTE
OPTICAL
INPUT
ON
ONLY WITH HIGH LEVEL INPUT
GND
WiFi BOX
HIGH LEVEL
INPUT
SPEAKER
OUTPUT
F+
F -
E+
E-
SPEAKER
OUTPUT
BATT.
+12V
G/H
LINE OUT
XE6440-DSP
6-CHANNEL AMPLIFIER WITH
DIGITAL SOUND PROCESSOR
POW.
PRT.
REMOTE
OPTICAL
INPUT PC CONNECT USB
AUX
INPUT
WiFi BOX
AUX
INPUT
REM
IN/OUT
REM IN/OUT
AUTO TURN ON
OFF
ON
ONLY WITH HIGH LEVEL INPUT
AUTO TURN ON
OFF
PC CONNECT USB
FUNCTIONAL INSTRUCTIONS
Click on Click here to test to check the connection with the DSP device.
If the test was performed successfully 4 checkmarks in the check boxes appear. Then press
„ [OK] Click here to start“ to continue.
Should one of the checkmarks not appear, a problem occurred that can lead to a malfunc-
tion. Please refer to the following instructions.
Error:
„ERROR“ message in connection between DSP device and your computer
Reason 1:
The DSP device is in PROTECT mode (protection circuit) or turned off.
Note: The POWER LED and the USB LED must light up blue.
Remedy:
Correct the cause
Reason 2:
The „MCU Upgrade“ on DSP device (see previous page), was not performed correctly or
not.
Remedy:
Run the „MCU Upgrade“ again.
Error:
„The COM port could not open...“ message in connection between DSP device and
your computer
Reason:
In the connection window after the software start the wrong COM port has been selected
or defined.
Remedy:
Select the correct port. Check if necessary the port in the Device Manager of Windows un-
der „Ports (COM & LPT) „USB-Serial CH340“.
The entry can be found at:
Settings > Control Panel > Administrative Tools > Computer Management
> Device Manager > Ports (COM & LPT)