12
CV
Name
Description
Range
Default
49
Extended Configuration #1
Additional important settings for LokSound Decoders
0 - 255
01
Bit
Description
Value
0
Enable Load control
Disable Load control
1
0
1
reserved
2
2
Reserved
4
3
Reserved
8
4
Automatic DCC speed step detection
Disable DCC speed step detection
Enable DCC speed step detection
0
16
5
LGB® function button mode
Disable LGB® function button mode
Enable LGB® function button mode
0
32
6
Zimo® Manual Function
Disable Zimo® Manual Function
Enable Zimo® Manual Function
0
64
7
Reserved
50
Analogue Mode
Selection of allowed analogue modes
0 - 3
06
Bit
Description
Value
0
Reserved
1
C Analogue mode
Disable DC Analogue mode
Enable DC Analogue Mode
0
2
51
«K Slow» Cutoff
Inernal Speedstep, until «K Slow» is active
0 - 255
10
52
Load Control param. «K» for slow driving „K“-component of the internal PI-controller for the low speed steps.
0 - 255
15
53
Control Reference voltage
Defines the Back EMF voltage, which the motor should generate at maximum speed. The
higher the efficiency of the motor, the higher this value may be set. If the engine does
not reach maximum speed, reduce this parameter.
0 - 255
120
54
Load control parameter „K“
„K“-component of the internal PI-controller. Defines the effect of load control. The
higher the value, the stronger the effect of Back EMF control.
0 - 255
30
55
Load control parameter „I“
„I“-component of the internal PI-controller. Defines the momentum (inertia) of the mo-
tor. The higher the momentum of the motor (large flywheel or bigger motor diameter,
the lower this value has to be set.
0 - 255
50
56
BEMF Influence at VMin
0-100%.
Defines the “Strengh” of the BEMF at minimum speed step
1 - 255
255
Programming table - List of most important CVs
Programming table - List of most important CVs
