Esu ECoSBoost, Инструкция по эксплуатации, Страница: 7 / 16

7
8.2.2. 9A Power supply
VIn: 100V – 240 V AC, 50 / 60 Hz
Input current: 3.6A max.
VOut: 19V DC, stabilisiert
Output current: 9.5A max.
Plug: 4-pin power Mini-DIN plug, 1.8m
wire harness
a) Power-LED (red)
b) Output socket (low voltage)
c) Main socket
Figure 4
a)
b)
c)
8.2.3. Connections
• First of all connect the power supply cable with the corresponding
socket of the power supply. Then plug the cable in an appropriate
power socket.
Figure 4 shows how to the power supply can be connected to the
ECoSBoostBoost.
• To ECoSBoostBoost 4A 50010: the power supply will be connec -
ted via a 2.1mm DC socket.
• To ECoSBoostBoost 8A 50011: the power supply will be connec -
ted via a 4-pin Mini-DIN socket.
Never use Y adapters for connecting the power supply to other
devices of your model railway layout besides the ECoSBoostBoost!
This could cause an inadmissible contact to ground that could lead
to the destruction of your ECoSBoostBoost!
The power supply generates a stabilised voltage that serves to po-
wer your model train layout. A voltage of 18V can be too high
for some N gauge decoders or locos. Therefore, we recommend
a lower track voltage when using the ECoSBoostBoost 4A for N
gauge layouts.
8.3. Track connection
The tracks are connected via a two-way socket with a removable
plug. Please make sure that you use cables of adequate size (cross-
section) for your track power. We recommend wires of at least
0.75mm² (better: 1.5mm²) cross section. In larger layouts connect
track power every two meters to the tracks.
ECoSBoost uses an H4-bridge (full bridge) for the track power.
Therefore with ECoSBoostBoost – contrary to older Märklin® sys-
tems - there is no „Common” (Ground).
Wiring details
ECoSBoost 4A 50010
ECoSBoost 8A 50011
Figure 5

