Esu 58315, Инструкция по установке и эксплуатации

Страница: 42 / 112

42
Installing the decoder
Figure 31: Cabling Reed contact at LokSound
input
ground
reed contact
4x miniature
magnet
6.11.2. Additional sensor inputs
The LokSound 5 L or XL LokSound 5 has two additional sensor inputs and
SENSOR1 SENSOR2 (see. Fig. 7/11 and Fig. 8/12) which can be used for the
triggering of noise. Reed contacts or Hall sensors are possible. The on-circuit
occurs as shown previously.
12.6. Connecting Capacitors
On many older plants, the current consumption of the locomotives is not optimal.
It may therefore be undesirable chenstraßen interruptions or jerks of the
locomotive during slow driving over WEI. Can through the use of buffer
capacitors (from 100 uF / 25V are results observed) advertising prevents. If
desired, you can connect them to the LokSound LokSound 5 or 5 micro.
Soldering on the decoder requires experience and good soldering equipment.
Damage caused by short circuits during soldering, not covered by the
warranty. Consider carefully if you really need the capacitor.
6.12.1. LokSound H0, LokSound Decoder
You can contact an electrolytic capacitor according to Figure 32 comparable.
The charging of the capacitor takes place via a resistor (100 ohms), thus not the
summed capacitor charging current is considered to be short when the digital
system. The diode ensures that the energy of the capacitor when required still is
fully available. then you can no longer use selspannungsanlagen on alternating
the sound decoders. Risk of destruction!
The capacitor must be prior to programming with the LokProgrammer
Disconnect / remove!
LokSound 5
LokSound 5 L
input
ground
reed contact
LokSound XL 5
reed contact
input
ground