ESTEBAN ELESSENS, Инструкция по применению

Страница: 8 / 32

8
2
STAGE 2
• Plug the appliance into a (mains) socket. Only use the electricity supply intended
for this purpose. Check that the electric plug is in conformity with your country's
electricity installation. If not, add a universal adapter to the plug (see non-exhaustive
list of countries on page 6).
• In order to avoid any accident, make sure that the cable is not located in an area
where people walk.
CLEANING
After each use, to avoid spotting and bad smells clean the
appliance by following these steps:
• switch it off and unplug from the mains
• remove the upper part A
• empty out the container by following the diagram shown in
STEP 4 of «STARTING THE DIFFUSER» to avoid any contact
with electrical parts
• clean the water container and the ceramic upper part in
order to remove all residues, for it use absorbent paper
impregnated with a mild detergent (soap, washing-up liquid…
Do not use aerosol sprays, solvents or abrasive products that
might damage the appliance).
Then wipe it with a dry cloth:
• use a soft cloth with a little of water if necessary to clean the
outside of the appliance
• use a wet cotton bud (water only) to clean the ceramic disk
• as this disk is very fragile and sensitive, make sure not
to press too strong and clean it after each use for longer
operating life.
NEW USE
• see STAGE 1 of the section «STARTING THE DIFFUSER»
• replace the water in the container frequently to avoid any
residue that might damage the appliance
• empty out the liquid remaining after each use and clean the
water container and its ceramic disk each time you change
the water or fragrance, for an optimum fragrance.
LONG PERIOD WITHOUT USE
If the appliance is not going to be used during a long period,
clean it, dry it (by following the instructions in section
«CLEANING»), and keep it in a dry place.
OPERATION AND MAINTENANCE INSTRUCTIONS
GB
bott un
3
STAGE 3
• Press the upper part of the diffuser, near the ON/OFF push button.
- First press : to start diffusion and scroll through the different coloured lights.
- 2
nd
press
: to settle on a light colour while diffusion continues.
- 3 rd press
: to switch off the light but allow diffusion to continue.
- 4
th
press
: to stop diffusion.
• The appliance stops automatically if there is not enough water.
• During the diffusion, the height of the mist may vary.
• When the appliance is operating, make sure not to put any obstacle above the
appliance that could hamper the release of the mist and not to remove the ceramic
upper part in order to avoid any splashing.
4
bott un
bott un
 
STAGE 4
• Unplug the appliance, then empty out the remaining water by following the diagram opposite and clean it (refer
to the «CLEANING» recommendations in the operation and maintenance instructions).
bott un