ESTEBAN CITY POP EDITION, Инструкция по применению

Страница: 9 / 32

9
9
• Recommended water: mineral water/tap water/at room temperature/low in limescale.
• Do not pour hot water into the container (risk of damage of sensitive components).
•
 Do not pour drops of refresher oils or essential oils into the container if there is no
water in it as this risks damaging the device.
• An excess of refresher oils or essential oils could prevent the diffusion and damage the diffuser.
• The harshest and most viscous essential oils should not be used as they may damage your diffuser.
• After each use, to avoid spotting and bad smells clean the appliance:
- clean the water container and the ceramic upper part in order to remove all residues, for it
use absorbent paper impregnated with a mild detergent (soap, washing-up liquid… Do not use
aerosol sprays, solvents or abrasive products that might damage the appliance). Then wipe it with
a dry cloth.
- use a soft cloth with a little of water if necessary to clean the outside of the appliance.
- to access the ceramic disk, turn the protective closing device counter clockwise.
Use a wet cotton bud (water only) to clean the ceramic disk ensuring you do not
press too hard. Reposition the closing device after cleaning.
REPAIR
If the product is not working properly, check the following points:
Problems / Symptoms Causes Solutions
No mist when the
appliance is switched on The appliance is not plugged in Ensure that the USB lead is correctly connected to the device
and the USB port
Water level too low Fill the water container
Water level exceeds 110 ml Empty out excess water
The end of part A is obstructed Make sure that nothing is preventing the release of the mist
Mist stops while the
diffuser is in operation Water level too low Fill the water container
Accumulation of water drops in the part A
Switch off the diffuser, remove part A then clean off the
accumulated water drops
Insufficient mist The ceramic disk is dirty Clean the ceramic disk as described in the « PRECAUTION
FOR USE » instructions
An excess of Estéban refresher oils or
essential oils has been poured into the
container Empty the appliance and clean it
Accumulation of water drops in the part A Switch off the diffuser, remove part A then clean off the
accumulated water drops
The light does not
switch on Diffuser failure Bring the diffuser back to the retailer within the after-sales
service support legal deadline
Should the problems persist please contact your retailer.
The manufacturer is not responsible for damages caused by improper use of the diffuser.
Power supply USB3 / 5V – 800mA
Mains Compatible with USB mains adapter. Output: 5V 1A
Power 4 W
Protective closing
device