14
po.org
MODEL: EST-MTB29 PRODUCT CODE: 704513 | MODEL: EST-MTB29M PRODUCT CODE: 704512 10/2021
AFTER SALES SUPPORT
info@tem
AUS
1300 112 534
Assembly (Cont.)
Step 5: Installing the Reflectors and Bell
CAUTION!
• Be sure the reflector is in the same longitudinal plane as the bicycle
(horizontal to the ground). If the reflector is aimed up or down, oncoming
headlights may not reflect properly in the reflector. If the reflector is not
horizontal to the ground, loosen the clamp screw and readjust the angle.
• It is important to check and adjust the position of the reflectors as you
assemble your bike. The reflectors must always be vertical (perpendicular to
the ground) and pointed toward the front and rear of the bike.
1. Remove the clamp screw from the reflector (or bell) bracket.
2. Push open the bracket “loop” and slide it onto the handlebar. (If there is a sizing
insert included with the bracket, please be sure it is inside the clamp loop before
mounting.)
3. Position the bell bracket (Fig. 13) or the reflector bracket (Fig. 14) at a certain
position on the handlebar and tighten the clamp screws securely.
Fig. 13
Fig. 14
Rear reflector (red)
1. Put the seat post mounted rear reflector in the
correct position by loosening the screws of the
rear reflector bracket (Fig. 15).
2. Make sure the rear reflector is vertical to the
ground and points straight back.
3. Make sure there is a minimum clearance of
7.5 cm between the top of the seat and the top of
the red rear reflector.
Fig. 15
