7
Remote Control
BUTTON
OPERATION
IMAGE
ON/OFF
Press to turn the fireplace, and the flame effect, on and off.
Note: The power and the flame effect must be on for the
heater to turn on.
DIMMER
Press to cycle the flame effect brightness through various
settings from High to Low, then back to High.
The ON/OFF button turns the flame effect on and off.
Note: The ember effect cannot be adjusted.
HEAT
Press to turn the heater on and off, and to select Low (LL) or
High (HH) heat.
Note: The power, and the flame effect, must be on for the
heater to work.
Note: The fan may continue to blow air for a short time to
cool the fireplace.
F
With the heat on, press to set the thermostat temperature.
The thermostat will automatically turn the heater on and off
to maintain the set temperature.
The set temperature appears in the control panel display.
Settings start at 68
F, increase by 2
F to 88
F, and then
start over.
The heater will only turn on if the thermostat setting is
higher than room temperature.
When the room temperature reaches the thermostat
setting, the heater will turn off.
Note: To override this, press the heat button.
TIME
The TIMER turns the fireplace off after a set amount of
time.
Press to select from the following timer settings:
00 (off), 30 (30 minutes), 1H, 2H, 3H, 4H, 5H, 6H, 7H, 8H,
and 9H.
The timer settings appear in the digital display. The display
will turn off after 10 seconds.
Temperature Limiting Control
This heater is equipped with a Temperature Limiting Control. Should the heater reach an unsafe
temperature, the heater will automatically turn OFF. To reset:
1. Unplug the power cord from the outlet.
2. Turn the ON/OFF switch on the CONTROL PANEL to OFF.
Wait 15 minutes.
3. Inspect the fireplace to make sure no vents are blocked, or clogged with dust or lint. If they are,
use a vacuum to clean the vent areas.
4. With the POWER switch in the OFF position, plug the power cord back into the outlet.
5. If it switches off again,
UNPLUG THE HEATER RIGHT AWAY!
Have the outlets, wiring, and
breaker box inspected by a professional. Make necessary repairs before using the heater.
NOTICE
When the heater is first turned on, a slight odor may be present. This is normal and
should not occur again unless the heater is not used for a long period of time.