9
Assembly instructions
4
Charging the Battery using the USB Power Adapter
□
Loosen screws (1) securing the battery pack (2) to the crank housing.
□
Carefully lift the battery pack from the crank housing compartment.
□
Connect the micro USB cable (a) to the micro USB charging port (b) on the back of
the battery pack.
□
Connect the USB plug end of the cable to a powered USB port on a computer or
other USB charging device (not included). A steady Red light (c) indicates the
battery is charging and steady Green light when unit is fully .
5
Charging the Battery using the Solar Panel
□
Place the fully assembled solar umbrella in full sun
where it will receive direct sunlight for at least
8 hours per day.
WARNING:
Use product with supplied 3.2v - 3.7v
/ 4000maH LiFePo battery pack only. Use of any
other batteries may create a risk of fire.
Note:
For first time use, charge unit for about 8
hours. USB charging device (power adapter) with
a rated output of between 1 – 7.5 Watts is
recommended. The lower the output the longer it
will take to charge battery.
Note:
Before operating, the batteries need to be
fully charged. The batteries may require up to 8-
hours of full sunlight and/or charging device (not
included) to fully charge.
Note:
The number of hours of LED light output
and sound output is directly proportional to the
number of hours of sunlight it receives. The solar
panels cannot recharge the batteries if light is
obstructed. Use a USB Power Adapter (not
included) in low or obstructed light locations.
Note:
Can use about 4 hours for music play and
LED lights when fully charged.
If out of power, use the solar panel to charge the
batteries for about 1 hour then open the LED
lights and music.
