Installation Method Alternatives
Care@Home™ Motion Detector User Guide
29
Using Screws
You can use screws to install the PIR:
Flat on a wall
At an angle facing to the right or the left
In a corner
Required Equipment
Before beginning, prepare the following equipment:
A drill with a standard bit
3 X 35 DIN 7982 C screws and wall anchors:
2 for installation on a flat wall
3 for installation at an angle
6 for installation in a corner
A standard Philips screwdriver
Installing the PIR with Screws
To install the PIR using screws:
1.
Release the PIR mounting base by lifting the tab and pushing it forward.
2.
Clean the surface where the PIR is to be installed.
3.
Use a flat screwdriver to clear the holes appropriate for the mounting location. Refer to
Screw
Holes
on page 30.
4.
Place and hold the mounting base on the desired location and mark the drilling spots.
5.
Drill the holes.
6.
Insert wall anchors if needed.
7.
Place the mounting base over the wall anchors and screw in the screws.
