Installing the MGLS
Care@Home™ Door/Window Sensor User Guide
7
When the battery is installed, the internal LED lights up red, indicating that the device has powered
up successfully.
Figure 5: LED
d.
Skip ahead to step 4 on page 8.
3.
If the MGLS is
not
from a Care@Home
™
kit, you must add the MGLS to the Care@Home
™
system.
a.
Press the
PAIRING
button, located on the right edge of the front of the CP, for five seconds.
b.
Move the MGLS at least 2 m (~6 ft. 7 in.) away from the CP.
c.
Press the tamper switch at least three times. Refer to paragraph 2a on page 6.
d.
Insert the battery, observing the correct polarity. Refer to paragraph 2c on page 6.
e.
Ensure that the pairing process is successful. The process can have the following results:
Success
The CP beeps and the CP
ring
blinks blue three times.
Failure
The CP beeps and the CP
ring
lights up red for two seconds. Try to
pair the MGLS again.
Already paired
The CP beeps, the CP
ring
lights up blue, and the
EMERGENCY
button
lights up red.
NOTE:
If no additional peripheral devices can be integrated, as when the CP
memory is full, the CP beeps and the CP
ring
lights up red.
LED
