ESPEC PLATINOUS CHAMBER Series, Руководство по настройкам

Страница: 35 / 93

Platinous Options Manual
Water Circuit
3.3 Controlled Low Humidity (ES-LH, 4)
3.3.1 Purpose
To operate the chamber at low humidity conditions. See specification for actual range.
3.3.2 Installation
The wick pan water level regulator is contained inside the water circuit compartment, located on the right
side of the chamber.
Procedure: Removal of Packing Material
1. Open the lids of both the water level regulators.
2. Take out the stopper sponges (protection material) found inside.
3. Note the position of the floats when the sponges are removed.
4. Return and close the lids to their original state.
FIGURE 3.2.
WATER LEVEL REGULATORS
Do not re-install float upside down!
The valve seat lock nut, fitted on the lid of the wick pan water level
regulator, and the float switch holder lock nut fitted on the
humidifying tray water level regulator are factory preset and should
not be turned.
The float for the wick pan water level regulator and the float for the humidifying tray will not
function properly if interchanged.
When re-adjusting either of the level regulators, refer to Chapter 5 - “Installation” in the
Platinous User’s Manual for instructions.
Air Supply Piping
Refer to “Dry Air Purge (ES-DA5,10)” on page 11
Valve Seat
Locknut
Lid
Sponge
Float
!
CAUTION