Esoteric K-01X, Руководство пользователя

Страница: 9 / 84

9
En
gl
is
h
Notes about the remote control
Precautions when using the remote control
o
When using the remote control, point it toward the remote con-
trol signal receiver on the main unit from a distance of 7 m (23 ft)
or less. Do not place obstructions between the main unit and the
remote control.
o
The remote control might not work if the remote control signal
receiver is exposed to direct sunlight or bright light.
o
Beware that use of this remote control could cause the unin-
tentional operation of other devices that can be controlled by
infrared rays.
Installing batteries
Remove the cover from the back of the remote control and insert
two AAA batteries with their
¥
/
^
oriented as shown in the case.
Replace the cover.
When to replace batteries
If the distance required between the remote and the main unit
decreases or if the unit stops responding to the remote buttons,
replace both batteries with new ones.
Dispose of the used batteries according to the instructions on them
or requirements set by your local municipality.
V CAUTION
Misuse of batteries could cause them to rupture or leak, which
might result in fire, injury or the staining of nearby materials.
Please read and observe the precautions on page 5 carefully.
Handling discs
o
Load discs with their labeled sides up.
(CDs only have one playable side.)
o
To remove a disc from its case, always press down on the center of
the case first and then hold the disc by its edges.
Removal from case Holding by edges
o
Be careful when handling discs. If the side that contains the data
(unlabeled side) is scratched, smudged with fingerprints or other-
wise dirty or marred, errors could occur during playback.
o
If the side of the disc that has the data encoded on it (unlabeled
side) becomes dirty with fingerprints or dust, use a soft cloth to
wipe the surface from the center directly toward the edge.
Always clean discs before storing them. Leaving a disc in an
unclean state might degrade its sound quality.
o
Never use record cleaners, antistatic treatments, thinners or similar
chemicals to clean discs. Such chemicals could harm the surface
of the disc.
o
Do not leave discs in places that are exposed to direct sunlight or
that are very humid or hot.
o
When writing something on the label side of a disc, use a felt-tip
permanent marker. The use of a ballpoint pen or other pen with a
hard tip could damage the disc, making it unplayable.
o
After you finish playing a disc, always put it back into its case for
storage. Failure to do so could result in warping or scratches.
o
Do not apply labels or other materials to discs. Do not use a disc
that has sticky residue left on its surface after removing tape or a
sticker, for example. If such a disc is loaded, it might become stuck
in the unit or damage the unit.
o
Never use commercially-available CD stabilizers. Doing so could
make the disc unplayable or damage the unit.
o
Do not use cracked discs because they could damage the unit.
o
Never use discs with irregular shapes, including heart-shaped and
octagonal discs, because they could damage the unit.
o
Do not use printable discs, which allow printing on the label
side. Since the surface of such a disc has been specially treated, if
loaded, it might become stuck in the unit or damage the unit.
If you have any questions about how to handle a CD-R or CD-RW
disc, contact the manufacturer of the disc directly.