ESI IVX 20, Руководство по установке

Страница: 27 / 55

IVX 20 Function 1: System parameters
D.1
Function 1: System parameters
Function 11: Initialize
This function will do one of the following:
•
Reset — Erases all programmed configuration data but does not delete custom recordings made
by the Installer or customer. After performing a reset, the system will match any previous custom
recordings to the new configuration data.
•
Initialize — Returns all components and software to their initial state. Initialization will erase all
data and custom recordings.
Important: Always initialize the system before initial programming for a new installation.
Important: The command to reset or initialize must be confirmed by entering the Installer pass-
word when prompted.
System reset or initialization will take up to two minutes to complete. When completed, the
phone’s display will return to the idle state.
You must then re-access Programming Mode by follow-
ing the steps described earlier (see page C.4).
Functions 12 and 13: Installer and Administrator passwords
These functions will display the existing password and prompt for input of a new password. The
passwords can be 2–8 digits long, followed by
# . The Installer can change either the Installer or
Administrator Password. Only those functions listed in the Administrator’s Manual can be pro-
grammed via the Administrator Password.
The default passwords are:
Installer Password (Function 12) = 7 8 9
Administrator Password (Function 13) = 4 5 6
Note: Be sure to write down the new passwords, store them in a safe place and give the new Ad-
ministrator’s Password to the Administrator.
Note: You can use either the Installer or Administrator password to access a user’s station pro-
gramming. At the station, when prompted for the user’s password, enter either the Installer
or Administrator password, then follow normal user programming procedures.
Function 14: Set time/date
1.
Enter a new time in a twelve -hour format. You do not need a leading zero for the time.
Example: Enter 1 2 3 3 for 12:33, or 3 1 5 for 3:15.
2.
Select
AM
or
PM
by pressing a scroll key (either
▼
or
▲
) .
3.
Enter a new date in an eight-digit format, including leading zeroes as necessary.
Example: Enter 0 7 0 4 2 0 0 0 for July 4, 2000.
4.
Press # to finish the entry.
Note: A built-in battery maintains the correct time and date, even in the event of a power loss.