All rights reserved. Reproduction as well as electronic duplication of this user guide, complete or in part, requires the written consent of
ESERA GmbH. Errors and technical modification subject to change.
ESERA GmbH, ESERA-Automation 2020
www.esera.de
11325 V2.0 R1.0 Manual
Page 2 of 8
Commissioning
How to Videos for commissioning and configuration can be found on our website
Service and Support, How to and Support Videos.
3
Technical Data
Connection:
Bluetooth, long distance data connection up to 100/30m
Bluetooth: V2.0 + DER, 2.4GHz frequency (2.42 to 2.48GHz), class 1
Transmission power max. +18dBm
Receiver: USB-Bluetooth- Adapter, Bluetooth Access Point
Range: approx. 100m in free field, approx. 30m in building
Terminal device interface: Virtual serial port via SPP
Supply voltage: 9-30VDC
Current consumption: max. 500mA
1-Wire interface: 1-Wire bus (5V, ground and data)
Protection circuits:
ESD and reverse polarity protection
Connection: screw terminals (up to 2.5qmm cable cross section)
Output voltage: 5V (+/-10%), max. 200mA, overload and short circuit proof
4
Ambient conditions
Temperature, operation -10°C to +55°C
Air humitidy:
10 - 92% (non-condensing)
Protection system:
IP20
Protection class:
III
Dimensions:
35 x 90 x 70mm (WxHxD)
5
Conformity
EN 50090-2-2
EN 61000-4-2, ESD
EN 61000-4-3, HF
EN 61000-4-4, Burst
EN 61000-4-5, Surge
EN 61000-6-1, interference immunity
EN 61000-6-3, interference radiation
RoHS
6
Software
In order to protect controller 1 from unauthorized access, a password/key must be entered before a data
connection is established. This signals to Controller 1 that the connection setup is an authorized access.
The factory default is key 1304
.
7
Setting up Bluetooth
A Bluetooth adapter must be available and set up on the end device, i.e. the device that is to exchange data with
the Bluetooth module. If a connection to controller 1 is then established, the driver software sets up a virtual COM
port on the device. Any application can then send and receive data via this port.
With a virtual COM port, the baud rate setting has no meaning, so that a baud rate of, for example, 19,200 bps
and 8N1 can be selected as transmission parameters.
7.1 Driver for Bluetooth - Adapter
Bluetooth adapters with USB interface or Bluetooth access point devices are available.
The drivers for the Bluetooth adapter must be set up on the control unit/computer according to the instructions of
the adapter manufacturer.
Depending on the operating system, the setup and the connection establishment will work slightly differently.
However, the Bluetooth adapters always set up a service or program that can be used to search for Bluetooth
devices in the vicinity. If a Controller 1 is in range, the device is recognized as Controller 1 (Serial Adapter) and a
connection can be established.
