ESD electronic CAN-CBM-PLC/331-1, Руководство по оборудованию

Страница: 67 / 149

i
Overview
CAN-CBM-SIO, CAN-CBM-SIO4 Software Rev. 1.0 1 - 3
1.2 Default Settings
The default settings of the manual are active, when one or more of the following conditions apply:
- A default RESET had been triggered on the module via the esd-CAN protocol.
- The data of the I²C-EEPROM are not OK (e.g. EEPROM is not equipped).
- The position of the coding switches after a RESET or power-on had been set to ‘00' and had then
be changed to another value.
Individual parameters can be changed without influencing the default setting of other parameters.
Changes in parameters are only retained after a RESET, if they had been stored in the EEPROM.
Default values when operating the module with the esd-CAN protocol
INIT-Id. in all operating modes $700
Rx-identifier,
Tx-identifier
RxId1, TxId1 - < serial channel 1
RxId2, TxId2 - < serial channel 2
RxId3, TxId3 -
<
serial channel 3
RxId4, TxId4 -
<
serial channel 4
RxId5, TxId5 -
<
serial channel 5
The default values of the identifiers correspond to the settings via
the coding switches. Please refer to the hardware manual for a
detailed description of the settings. (*)
Module No. = setting of the coding switches
CAN-bit rate = 125 kbit/s
(*) Please note that the CAN-CBM-SIO4 module covers five Tx- and five Rx-identifiers. Therefore, the identifiers of
the following modules have to be selected with an offset of at least +10, because otherwise the identifiers would
clash!
Table 1.2.1:
Default settings of the module when operated with the esd protocol
Attention:
The terminal interface (at DSUB9) on the CAN-CBM-SIO4 module has been
assigned with Rx-identifier RxId
5
and Tx-identifier TxId
5
. On the CAN-CBM-SIO module with
only one serial interface, however, the terminal interface has been assigned with Rx-identifier
RxId
1
and Tx-identifier TxId
1
.